More on Solidrains

Installation Instructions: To connect the fittings to the spiral surface of the pipe, coat four to six fundamental difference points of the tube, with SOLISEAL glue and rotate in order the fitting to be screwed. By that way, the glue is distributed over the total welding surface of the pipe. SOLISEAL is a special glue, polyurethane based, that with humidity, is polymerized in strong rubber that is very resistant to temperature changes or weather conditions and has high adhesion. This system can operate with safety, 24 hours after SOLISEAL application, necessary time required for its polymerization. This time is inversely proportional with the humidity of the place. That means that the bigger the humidity in the area, the lessen time is needed for polymerizing of SOLISEAL. To weld the cylindrical smooth surfaces of the fittings with the entrance of the waterspouts, you must use the special glue for PVC. In case that the waterspout is waterproofed with rubber rings, the fitting waterproofs by tightening nuts. If in the bathroom (under installation), the entrances of the waterspout are not sufficient (total 4) and you need one more, there is the possibility to increase them by using a semi tee Φ40. With its application, every entrance of the waterspout is divided into two individual.

TECHNICAL CHARACTERISTICS-PROPERTIES
Video: SOLIDRAINS (Bathroom & kitchen drainage system)

Solidrains – Related

FLEXIBLE SPIRAL PIPES

FLOOR WATER TRAP

GREY COUPLING